PSI to Inches of Water

About PSI to Inches of Water

This site turns psi into inches of water and shows you what that pressure looks like.

The problem this site solves

A furnace data plate asks for 3.5 inches of water column at the gas valve. The test gauge in your hand reads in psi. What should the needle show? The answer is 0.126 psi, too small for many psi gauges to show. That gap between the units on the job and the units on the tool is why this site exists.

Inches of water is the unit for small pressures: gas lines, duct fans, filters, cleanroom walls, chimney draft. psi is the unit for almost everything else. People switch between them all day, and a wrong decimal can mean a furnace that won't light or a filter changed months too early.

What each part of the converter does

Two boxes that work both ways

Type in the psi box or the inH₂O box. The other one updates as you type. Use the arrow keys to step the value up or down by 1, hold Shift for 10, or Alt for 0.1.

Slider and quick values

The slider runs from 0.01 to 1000 psi on a log scale, so small and large pressures both get room. The quick buttons load common values in one click: 0.1, 0.25, 0.5, 1, 5, 100 psi and one standard atmosphere.

Water reference temperature

Water gets lighter as it warms, so the same pressure holds up a taller column. Pick the temperature your gauge was calibrated at: 39.2 °F, 60 °F or 68 °F. The gap looks tiny at 1 psi (27.68 vs 27.73 inH₂O). At 100 psi it grows to almost 5 inches.

U‑tube manometer

This is a drawing of the instrument people have used to read low pressure for centuries. Pressure pushes the water down on the left. The right side is open to the air, so the water rises there. The height gap between the two sides is your reading. The ruler rescales as the number grows, and a vacuum flips the levels.

Pressure gauge

If you think in needles, the dial shows the same pressure in psi. Its scale adjusts so the needle never pins at the end.

"How tall is that?"

Numbers like 406.8 inches don't mean much on their own. So the scale compares the column with things you know: a coin, a door, a house, the Eiffel Tower. One standard atmosphere lifts water about 34 feet, higher than a two‑story house.

Eight more units

Every result shows feet, centimetres and millimetres of water, kPa, mbar, inches and millimetres of mercury, and atmospheres. Click any tile to copy it.

Table, formula and shareable links

The conversion table covers 0.01 to 100 psi. Click a row to load it into the converter. The formula section shows the factor for each temperature, so you can check the math by hand. When you change a value, the page address updates too, so you can bookmark a result or send it to a colleague.

18 languages

The converter page is available in English, Hindi, Spanish, Russian, French, German, Italian, Portuguese, Bengali, Japanese, Korean, Malay, Polish, Indonesian, Arabic, Bulgarian, Turkish and Swedish. Pick yours at the bottom of any page.

Who uses it

Where the numbers come from

The results are good for field work, estimates and teaching. For calibration or safety sign‑off, check against your instrument's documentation.

Who runs this site

PSI to Inches of Water is an independent website. It has no ties to any gauge maker, utility or standards body. The owner writes the code, checks the factors against published references and reads every message. The converter is free, needs no account, and runs in your browser.

Found a mistake?

Tell us. Send the value you entered and the result you expected through the contact page, or email [email protected].